STARBORE. The vertical machine occupies the least possible space, it is a whole new record to have a cnc drilling center in only 1m2 of your workshop.
The piece to be machined always rests on one of the edges, all its weight resides on that part, the
special plastic table, it only acts as a guide in the movement, thus avoiding scratches on its finish
superficial, so that the visible part of the furniture does not suffer friction.
Thanks to the force of gravity, the piece is always in contact with the base, the zero point of all measurements, it does not need an adjustable clamp, avoiding wasting time adjusting the machine for each piece, as occurs in horizontal systems.
Jobs that STARBORE can do
-Holes of any diameter (interpolated milling).
-Eccentric holes (fittings for quick assembly).
-Kitchen hinge holes, configurable to any brand on the market.
-Cutter slots in any direction.
-Millings and drawings.
Software
Gcode Designer software, certainly one of the most intuitive on the market, provides ease of use, speed and flexibility. With the possibility of doing so from the comfort of the office, without taking up machine time in programming, it is sent via WiFi signal (1) copying the information into the memory of the machine itself or on a flash drive, and it is carried out machine, by means of menu selection or by reading the barcode, the program is loaded.
TECHNICAL DATA
STARBORE (dimensions in mm)
Y-axis (maximum drilling position) 900
Maximum Grooving Height with cutter 900
X axis 2600
Z axis (material thickness) (optional 10-50) 0-40
travel speed 15m/min
Minimum piece to machine. (x)150 (y)30
Maximum piece height 920
Head motor (2 units) 1HP/ 18000rpm
Packing: (mm) 1600x600x1700
Required air pressure 6 Kg/cm2
Weight approx (kg) 300
Why is the electronic probe necessary?
We know that most artisans make cuts with traditional squaring machines, as a result there are always small errors in the length of the cut and in the squares of the piece.
STARTBORE standard equipment
* Numerical control Vertimaq closed loop.
* GCode Designer design program, specific for carpentry.
* Configured to drill parts on the machine.
* 2 Milling Motor Units 1 hp / 18000rpm.
* Voltage: Single phase 220V (inverter converts to three phase)
* Electronic probe to correct the length of the piece and the position of the holes with respect to square deviations.
* Centralized manual greasing (optional).
CE regulations
Reviews
There are no reviews yet.